APS 12.5" Keymod Spyder Gel Blaster with Edge II Gear Box

APS 12.5" Keymod Spyder Gel Blaster with Edge II Gear Box

Do you like the TE Spyder but are after something a little longer, then this cutting edge gel blaster is for you. 

The full metal receiver is coated with a matte black finish and features stamped trademarks for a realistic look and feel.

The full length 20mm top rail is great for any type of optics you decide to use and the 12.5" Keymod style rail comes complete with 3 additional accessory rails for lights, lasers, vertical grip, and other tactical add-ons.

A retractable crane stock finishes off the rear of the blaster while an aggressive mock compensator finishes off the front.

The EDGE II gearbox comes with a micro mosfet system similar to the easyfet. 

Shooting approximately 290-310 FPS on Gelsoft Ultra Hard Gels! 

**Orange tip shown for illustration purposes**

About APS

APS Limited was established in 2001. APS started by specializing in designing and building Simulation Training Equipment (Real Action Markers & Powder Balls for training simulation). APS - the three words stand for Accuracy - Pneumatics - Shooting. With their knowledge and experience, APS launched a new product line - Electronic Blow Back (EBB) products to spur the current Gelsoft Market. Since entering the Gel Blaster industry their line of Gel rifles, pistols and accessories have been incredibly popular.

Features

Specs

In The Box:

• 1x   APS 12.5" Keymod Spyder Gel Blaster with Edge II Gear Box
• 1x Gen 8 magazine
• 1x safety glasses 

Always use the appropriate eye wear and take all reasonable safety precautions when using our products.

Soaking & Storage of Gels

When soaking the gels, they need to be soaked fully submerged in warm water from the tap for a minimum of 4-6 hours.

Once they have fully grown you can leave them in the water and keep them in or out of the refrigerator.

When you are ready to use them just drain off any excess water with a strainer before you feed them into the mag but do not dry them as they need to be lubricated to work properly.

DISCLAIMER

Do not upgrade any part of your toy gel blaster as this will void the warranty. Upgrades refer to pulling any of the blaster apart or opening it up, changing springs or upgrading the battery from 7.4v to an 11.v battery.